I tried touching it up by rolling on some poly but the finish is matte and somewhat cloudy from.
Missed spot polyurethane floor.
There s a sheen difference on the missed spots but the color is consistent.
I put a final coat of polyurethane on my wood floors and noticed that i missed a spot where my roller didn t overlap in application after the floor completely dried.
How can i fix this without compounding the problem.
I have had repairs done on oak floors that resulted in refinishing small areas.
Missed spots in polyurethane on hardwood floor.
Sand the area clean it with a solvent afterwards denatured alcohol apply polyurethane let dry.
Once the finish is dry you can do minor repairs and that s easier than repairing a big area of overworked finish.
If you see a small puddle or a spot you missed 6 feet out don t touch it.
Spot refinishing hardwood floors.
Missed a spot applying poly.
It looks remarkably good.
Typically two to three coats are used with sanding in between coats to even them out.
The dull and shiny spots in your hardwood floor indicate that your installers did not apply the finish correctly.
I put a final coat of polyurethane on my wood floors and noticed that i missed a spot where my roller didn t overlap in application after the floor completely dried i tried touching it up by rolling on some poly but the finish is matte and somewhat cloudy from what i first applied.
I assume that you have a polyurethane floor so i will base my answer on that.
Hardwood floors add a warm and natural glow to any room.
Dull spots in polyurethane floors usually indicate that the finish was not applied carefully the applicator had a dry spot on it or the finish was thinned out with a solvent such as mineral spirits.
I am using minwax super fast drying clear satin.
Use solvent based polyurethane and get the same finish type gloss satin etc and apply a few thick coats.
But even the most careful.
The part i missed is pretty evident in the correct light.
When it comes to finishing furniture or hardwood floors polyurethane is the key to protecting and preserving the stain.
Focus on that one small area and ignore the rest of the floor.
I m wondering how long this coat will really last given it wasn t sanded first.
While applying the last coat of poly to a traditional 3 4 red oak strip floor in poor light i didn t overlap the edge for about about 10 12 and the width of one of the boards.
Applying polyurethane in even coats is a crucial though not always simple task.
With a little tender loving care they can keep their soft shine for years.
This is how to polyurethane a spot on the floor with that refinishing the floor.